Active Wall Plate − HDMI over Twisted Pair ReceiverThe WP−572 is a DGKat™ twisted pair receiver for HDMI signals. The WP−571 converts an HDMI signal to a single twisted pair signal and the WP−572 converts the twisted pair signal back to an HDMI signal.- Max. Data Rate - 4.95Gbps (1.65Gbps per graphic channel).- HDTV Compatible.- HDCP Compliant.- DGKat™ Signal Integration - Kramer’s unique technology for converting TMDS as well as control and communication to signals that run over twisted pair cables. We strongly recommend using Kramer DGKat™ cables designed specifically for optimum performance.- HDMI Support - x.v.Color™, up to 7.1 Uncompressed Audio Channels.- 3D Pass-Through.- System Range - Up to 90m (295ft) at 1080i, or up to 30m (98ft) at 1080p on shielded BC-DGKat524 cable. Up to 90m (295ft) at 1080i, or up to 70m (230ft) at 1080p on shielded BC-DGKat623 cable. Up to 100m (330ft) at 1080i or up to 90m (295ft) at 1080p on shielded BC-DGKat7a23 cable.- Cable - Requires shielded twisted pair (STP) cable. For optimum range and performance use, use Kramer's BC-DGKat524, BC-DGKat623 and BC-DGKat7a23 cables. Note that the transmission range depends on the signal resolution, graphics card and display used. The distance using non-Kramer CAT 5, CAT 6, and CAT 7 cables may not reach these ranges. Use only shielded cable where both ends of the shield are soldered to ground.- EDID PassThru - Passes EDID signals between the source and display.- ON LED - Lights red when receiving power only, orange when either input or output and power are attached, and green when both an active input and output are attached.- Power Connect™ System - A single connection to the transmitter powers the receiver.- Dimensions - 3.3cm x 3.6cm x 10.4cm (1.3" x 1.42" x 4.1") W, D, H.- Wall Plate Size - 1 gang US.