Isolators

ADD-RS232-2ST is a Serial Media Converter that allows the conversion from a RS232 Port to Fiber via a 1310nm single-mode fiber (SMF) ST connector, allowing a distance reach up to 20km. ADD-RS232-2ST provides a cost effective conversion from Serial RS232...

ADD-RS232-2SC is a Serial Media Converter that allows the conversion from a RS232 Port to Fiber via a 1310nm single-mode fiber (SMF) SC connector, allowing a distance reach up to 20km. ADD-RS232-2SC provides a cost effective conversion from Serial RS232...

ADAM-4561/4562 allows PC users to connect a serial device to a system that use a USB interface. To attach the ADAM-4561/4562 to a PC, you don’t need to open the chassis or power down your PC. Instantly get one or two extra high-speed RS-232/422/485 ports...

9PFLST The 9PFLST allows any two pieces of RS-232 asynchronous serial equipment to communicate full-duplex over two multi-mode fibers. Typical distances up to 2.5 miles (4 km) are possible with no external power required. The 9PFLST supports both data...

9POP4 The 9POP4 isolates and protects RS-232 equipment from lightning surges, accidental high voltage shorts, and ground loops. RS-232 data signals TD, RD, RTS, and CTS are supported at up to 230.4 kbps. Isolation circuits are 2.5 kV rated and protects...

B&B Electronics 9SPOP2. Width: 2.4" (61 mm), Depth: 1.3" (33 mm), Height: 0.669" (17 mm). Certification: FCC Part 15, CISPR, EN 55022: 2010 + AC:2011 Class A, CE, EN 61000-6-1: 2007, EN 61000-4-2: 2009,...

The 485TBLED converts unbalanced, full duplex RS -232 signals to balanced, full or half-duplex RS-422 or RS-485 signals. RS -485 is an enhanced version of the RS-422 Standard. It allows multiple drivers and receivers on a two -wire or four-wire system...

RS-422/485 Isolated Repeater The 485OPDR is an optically isolated RS-422/485 isolated line repeater that can be used to isolate a piece of equipment from the rest of the network. As a repeater, it extends the distance of an existing network an additional...

RS-232 TO RS-485 CONVERTERS Model 485COSR is an economical converter that supports both 2-wire and 4-wire RS-485 communications. There is also provision for constant enable of the receiver during transmit for full duplex operation. Model 485TBLED is one...

RS-232 to RS-485 Converter This RS-232 to RS-485 converter converts unbalanced, full-duplex RS-232 signals to balanced, full-duplex or half-duplex RS-485 signals. RS-485 is an enhanced version osf the RS-422 balanced line standard. It allows multiple...

Port-Powered RS-232 to RS-422 Converter The 422LP9R is a port-powered two-channel RS-232 to RS-422 converter. It converts TD and RD RS-232 lines to balanced RS-422 signals. The unit is powered from the RS-232 handshake lines DTR and RTS. One of these...

Optically Isolated RS-422/485 Repeaters Model 485OP is an optically isolated RS-422/485 signal repeater. In addition to 2KV isolation on the data lines, it can be used to extend RS-422/485 circuits an additional 1.2 km (4,000 ft.), thereby doubling the...