8783-1 - Omnitron ICONVERTER MC RS422/485 DB9 TO

Managed Serial RS422/485 to Fiber Media Converter- Managed Serial RS-422 and RS-485 to fiber media converter with automatic Full-Duplex baud rate detection- Supports baud rates ranging from 110 to 921,600 baud- Supports multimode, single-mode and single-fiber with ST, SC, LC and MT-RJ connector options- Supports distances up to 5km on multimode and 120km on single-mode- Supports DB-9 and Terminal Block connector options for serial interface- Features built-in configurable terminators- Features configurable baud rate for Half-Duplex RS-485 and Full-Duplex RS-485 operation- Supports RTS and CTS controls- Supports Point-to-Point Half and Full-Duplex, Multi- Point Full-Duplex, and either Head, Tail or Mid-Position- Features remote Fiber Loopback DIP-switch for easy testing of fiber link, even during serial transmission- Management is available with the addition of a management module to the chassis- SNMP management via NetOutlook provides real-time port and module information, remote parameter configuration and trap notification- Modules are hot-swappable in 19-Module, 5-Module, 2-Module or 1-Module chassis- Lifetime Warranty and free 24/7 Technical SupportThe Omnitron iConverter RS422/485 is a managed serial RS-422 and RS-485 to fiber converter that transmits serial protocol over fiber media. Fiber transmission extends serial signals up to 120km, and is immune from electrical and magnetic interference.The RS422/485 is available with a single-mode, multimode or single-fiber transceiver. The serial port interface is available with either a DB-9 female connector or terminal block connector for field wiring.The RS422/485 automatically detects the signal baud rate of connected Full-Duplex serial device, ranging from 110 to 921,600 baud. It also automatically adjusts to changes in the connected device's Full-Duplex baud rate during operation without reconfiguration or interruption of service.Half-Duplex RS-485 and Full-Duplex RS-485 (sometimes referred to as Multipoint RS-422) operations are supported via a configurable baud rate DIP-switch to match the master/slave communication timing.Connection to DTE or DCE devices is configured by an easily accessible DIP-switch on the front-panel. This feature eliminates the need to use a specific serial cable for each type of device.A built-in remote Fiber Loopback DIP-switch provides easy validation of the entire fiber segment without interrupting fiber operations.Integrated configurable terminators support RS-422 and RS-485 operations, allowing the unit to be deployed at any node in the serial line.iConverter RS422/485 modules are hot-swappable and can be mounted in a 19-Module (2U high) or 5-Module (1U high) rack-mountable chassis (19-inch or 23-inch) with any combination of redundant AC, 24VDC or 48VDC power supplies. They can also be mounted in a 2-Module AC or 18 to 60VDC powered chassis, or in a 1-Module AC/DC powered chassis.The iConverter family of managed fiber access media converters are used in Service Provider access networks and Enterprise LANs. iConverter media converters provide fiber connectivity with copper-to-fiber, multimode fiber to single-mode fiber, or dual fiber to single-fiber conversions.